Basement steam shower in Rochester, MI

Featured project. Rochester, Michigan

A basement shower rebuilt to hold steam

This Rochester homeowner had a tiled shower in the basement and wanted a real steam room in its place. We tore out the old shower, added a steam generator on its own circuit and sealed every surface, ceiling included, before the tile went on.

LocationRochester, Michigan
ProjectBasement steam shower
Completed2026
InvestmentAbout $40,700

A basement steam shower in Rochester

The owner in Rochester came to us for one specific build: a steam shower in place of the basement’s existing tile shower. Rochester is roughly 50 miles from our Ypsilanti office, and the proposal priced that distance as its own travel line instead of folding it into the labor.

The proposal came in at about $37,000. One change order added about $3,700 of labor to finish the tile, which brought the final to about $40,700. It’s our first homeowner project featured from Oakland County, and a good example of what changes when a shower has to hold vapor, not just water.

What we built

Wood-look tile, a marble-look wall and a bench

Basement steam shower in Rochester with wood-look plank tile, a built-in corner bench and a dark marble-look feature wall
The room

A bench along two walls and a feature panel

The finished shower wraps wood-look plank tile around the room, with a long marble-look panel set into the back wall and a tiled bench that turns the corner. Black fixtures, including a handheld shower and the wall controls, keep the finishes consistent. It reads more like a spa room than a typical basement bathroom.

Long recessed niche with a marble-look back and black trim set into wood-look tile in a Rochester steam shower
The niche

A long niche trimmed in black

A long recessed niche is set into the side wall, backed with the same marble-look tile and edged in black trim. In a steam room, every opening is another place vapor can escape, so the niche sits inside the same sealed walls as the rest of the shower. Our bathroom remodeling crews plan niches before the walls are closed.

The details

Sealed walls, floor and ceiling

A regular shower only has to keep water in. A steam shower also has to keep vapor in, so the prep is different. We removed the drop ceiling over the old shower, framed a new ceiling so a vapor barrier could go on it, insulated the ceiling and walls to hold heat and vapor-proofed every surface before any tile went up. A GoBoard drain went in at the floor.

Steam filling a finished basement steam shower in Rochester, Michigan
Steam building with the generator running.
Wood-look tile steam shower with a long marble-look feature panel, built-in bench and black shower controls in Rochester
The bench, the feature wall and the shower controls.

The generator and its own circuit

The steam comes from a generator set by our plumbing contractor, and our electrician ran a separate circuit just for it. Steam generators draw far more power than a vent fan or a light, which is why they don’t share a circuit. If you’re comparing a steam room with a dry heat room, our sauna installation page covers the other option.

Around the shower

The floor, the ceiling and the glass that came later

These photos were taken before the glass door went in. Our glass contractor fitted the frameless glass door after the shoot, so the room you see here is open on the front side.

Sealed ceiling above a basement steam shower in Rochester, with wood-look tile walls and a marble-look panel
The sealed ceiling above the shower.
Light stone-look floor tile sloped to a square drain in a Rochester basement steam shower
Light floor tile sloping to a square drain.
Steam rolling across the bench side of a wood-look tile steam shower in a Rochester basement
Steam along the bench side of the shower.
Black handheld shower and steam controls beside a marble-look feature wall in a Rochester basement steam shower
Handheld shower and controls on the side wall.

The scope, line by line

This is what the approved proposal and its one change order covered. Electrical, plumbing and glass were handled by our contracted trades.

Demolition

Old shower and drop ceiling out

The existing tile shower and the drop ceiling above it were removed.

Plumbing

Drain and steam generator

A new GoBoard shower drain and a steam generator, set by our plumbing contractor.

Electrical

Its own circuit

A circuit added to the bathroom just for the steam generator.

Ceiling

Framed, insulated and sealed

New ceiling framing so a vapor barrier could be applied, with insulation to hold heat.

Walls

Insulated and vapor-proofed

Walls insulated, then every surface vapor-proofed before tile.

Tile

Walls, floor, bench and niche

Wood-look and marble-look tile, with a change order for added finishing labor.

Glass

Frameless enclosure

Frameless glass with a door from our glass contractor, fitted after these photos.

Questions we hear

Steam showers in Michigan basements

Can an existing basement shower become a steam shower?

Often, yes. It needs a sealed ceiling, vapor-proofed walls and floor, a separate circuit and a spot for the generator. If the space works, the conversion can happen inside the room you already have, the way it did here. Our steam room page explains the parts in more detail.

Do you work outside Washtenaw County?

Yes. We serve six counties across Southeast Michigan, from Monroe to Macomb, and this proposal priced the travel on its own line. Our design-build process runs the same way in Rochester as it does in Ypsilanti.

Thinking about a steam shower for your basement?

Send us a few photos of the bathroom you have now. We’ll tell you what it takes to seal it for steam and what it will cost, line by line.

(734) 540-0347